RV Awnings

Replacing Awning Fabric

Torn or sun-faded fabric can be replaced at home with the right preparation. Spring tension is the one thing to take seriously.

Replacing the fabric on a manual roll-up awning is a job many owners can do in an afternoon with a helper. The key is to respect the spring inside the roller tube and to measure carefully before ordering fabric. Electric awnings are more involved and are often best left to a technician.

⚠️ Safety First

  • The roller tube holds spring tension. Lock it in place before removing any fasteners and never release it suddenly.
  • Work with a helper — the awning is awkward and heavy.
  • Wear gloves and eye protection when removing fasteners and end caps.

🧰 Tools & Materials

  • Two or more locking pliers or clamps
  • Screwdriver set and nut driver
  • Tape measure
  • Replacement fabric sized for your awning
  • Rubber mallet
  • Lubricant for the roller tube and arms (check the manufacturer’s advice)

📋 Step by Step

1 Identify the awning and measure

Correct measurements prevent a costly mistake.

  • Note the brand and model, and whether the awning is manual or electric.
  • Measure the length of the roller tube and compare it to the fabric you order.
  • Choose vinyl or acrylic fabric to match your use and climate.

2 Lock the spring tension

This is the safety step.

  • Extend the awning a little, then lock the roller with clamps or locking pliers at the point your manual shows.
  • Support the arms so they can’t swing.

3 Remove the old fabric

Take notes and photos as you go.

  • Remove the end caps and the fasteners holding the fabric to the roller.
  • Slide the fabric out of the roller groove and the wall rail.

4 Install the new fabric

Keep it straight from the start.

  • Feed the new fabric into the roller groove and the rail, checking that it sits square.
  • Tape a guide line to keep it straight while you roll.
  • Refit the end caps and fasteners.

5 Test and adjust

Make sure it rolls evenly and holds tension.

  • Release the locks carefully and roll the awning in and out.
  • Check for even tension and no creasing.

🔧 When to Call a Professional

Stop and book a qualified technician if you see any of these:

  • An electric awning motor or gearbox fault
  • A damaged roller tube, arm or bracket
  • Spring tension you’re not comfortable handling
  • Large or complex slide-topper installations

❄️ Awnings in snow and wind

Retract the awning in strong winds, heavy rain and before snow — pooled water and snow can bend arms and tear fabric. Dry the fabric before rolling it up for storage to prevent mildew, and rinse off salt and road grime after winter trips.

🔧 Awning past a DIY fix? Find a technician

If the checks above do not fix it, look for an RV awning and canvas repair: a mobile RV technician or an awning and canvas shop for fabric replacement, arm repair and motor problems.

Bring in a professional when

  • The arms are bent or the motor fails
  • The torsion spring is under tension (do not release it)
  • The roller tube is damaged
  • You are unsure about measuring for new fabric

When you call, say

Mention brand and model, awning length and what failed.

Worth asking

Ask whether they replace fabric only or the whole awning, and the lead time on your model.

Find RV service in your province

Browse the full RV repair directory · How to choose a shop · Territories: Yukon, Northwest Territories

🛒 Awning fabric and tools on Amazon.ca

Search for awning fabric and tools on Amazon.ca.

🛍️ Search Amazon.ca →

Prefer a professional, or want a related guide?

Find RV Repair HelpRoof Sealant & Seam RepairSlide-Out RepairAll Repair Guides